Rapier loom: matters needing attention when the total number of rapier loom is more


Efforts to improve the output and operating performance of rapier looms, improve weaving efficiency and product quality, is the goal of machine manufacturers to participate in world competition. If the total number of roots is large, it is recommended to increase the number of heald frames, so as to effectively prevent the rate of breaking. Then the matters needing attention on the machine at this time are:


jMIQ8yCJTPmiMZMchrYzWQ.jpg



efforts to improverapier loomThe production and operation performance, improve the weaving efficiency and product quality, is the machine manufacturer to participate in the world competition goal. If the total number of roots is large, it is recommended to increase the number of heald frames, so as to effectively prevent the rate of breaking. Then the matters needing attention on the machine at this time are:

1. The reed is 1mm ~ 2mm away from the weft scissors. This benchmark should be set well. If the distance is greater than this, the weft will enter the scissors, causing weft breakage and wasting weft. If the distance is less than this, the reed will collide with the scissors. In addition, the steel leather strip under the reed should be padded well.

2. One person should tighten the screw to the end. If two people are tightened, separate from the middle and tighten to both sides at the same time.

3. The machine should be knotted by one person, the warp tension should be uniform, and the broken ends should be less.

4. Check the gear condition of the beam shaft and tighten the foot screw.

5, the film can not be confused, and must be flexible.

6. After weaving a piece of cloth, cut off the knot of warp yarn to let it pass through the cloth guide stick smoothly.

7. Check the swelling force of waste side yarn and the swelling force of twisted side yarn.

8, on the machine to adjust the coiling weft dense teeth, coiling support a few teeth to see whether it is too slippery.

9. Check the cloth surface for every meter of cloth woven. Bad cloth cannot be woven. At the same time, the length of waste yarn, the length of burrs on the cloth edge and whether the twisted edge is good can be found in time.


















Rapier Loom, Towel Loom, Trademark Loom

RELATED INFORMATION


The first 6S knowledge competition of Jinde loom has come to an end.

The First 6S Knowledge Competition of Jinde Loom has come to an end

2023-06-01

[Reprint] Southern Client | Contes: Building the Fastest Rapier Loom in China

"Southern Client" published "Contes: Building the Fastest Rapier Loom in China | Gaoming Industry Research ④" and introduced Jinde Loom. The following is the full text.

2023-06-01